Alarm SAF RMBE Series Manual de instrucciones descargar pdf (Pagina 3)

AlarmSaf, Inc. 65A Industrial Way, Wilmington, MA 01887 978-658-6717 www.alarmsaf.com

SINGLE VOLTAGE SYSTEMS

All single voltage systems use one power supply, user selectable for

12VDC, 8A or 24VDC, 4A.



RMDC-PS5-M: Single voltage, single output system.



RMDC-PS5-M-UL-FAI: Single voltage system with FAI accessory

module provides a single uncontrolled output and a single FAI

controlled output.



RMDC-1248(F): Single voltage system with eight (8) power

distributed outputs. Available with either fuse protected or power

limited outputs.



RMDC-PS5-M-8(F)-UL-FAI: Single voltage system with FAI

accessory module and eight (8) power distributed outputs,

individually selectable for FAI control. Available with either fuse

protected or power limited outputs.

DUAL VOLTAGE SYSTEMS

All dual voltage systems use two power supplies; each is user selectable

for 12VDC, 8A or 24VDC, 4A.



RMDC-PS5-MD: Provides two (2) independent power supply

outputs, each 12 or 24VDC, user selectable.



RMDC-PS5-MD-UL-FAI: Dual voltage system with 2 FAI accessory

modules provides dual uncontrolled outputs and dual FAI controlled

outputs. Each uncontrolled/FAI output pair is user selectable for

12 or 24VDC.



RMDC-12416(F): Dual voltage system with sixteen (16) power

distributed outputs, individually selectable for operation from

either power supply. Available with either fuse protected or power

limited outputs.



RMDC-PS5-MD-16(F)-UL-FAI: Dual Voltage system with two (2)

FAI accessory modules and sixteen (16) power distributed outputs.

Each bank of eight (8) outputs is user selectable for 12 or 24VDC,

while each output is individually selectable for FAI control. Available

with either fuse protected or power limited outputs.

RMDC Series Installation Instructions 52-376 Rev B01

NFPA STANDARDS

NFPA 72 National Fire Alarm Code

NFPA 70 National Electrical Code

NFPA 731 Standard for the Installation of Electronic

Premises Security Systems

US STANDARDS

UL/ANSI 294 Access Control System Units

UL/ANSI 1076 Proprietary Burgler Alarm Units and Systems

UL/ANSI 1481 Power Supplies for Fire Protective Signaling System

UL/ANSI 2044 Commercial Closed-Circuit Television Equipment

OTHER STANDARDS

NY MEA Listed

California State Fire Marshal (CSFM) Listed

Applicable Local and State Building Codes

Requirements of the Local Authority Having Jurisdiction (LAHJ)

CANADIAN STANDARDS

ULC S318 Standard for Power Supplies for Burglar Alarm Systems

ULC S527 Standard for Control Units for Fire Alarm Systems

CAN/CSA-C22.2 No. 107.1-01 General Use Power Supplies

OTHER APPLICABLE ALARMSAF DOCUMENTS

52-382 FAIM Installation Manual

52-342 RMBE Installation Manual

FCC COMPLIANCE

This equipment has been tested and found to comply with the limits

for Class A digital device pursuant to Part 15 of FCC rules. These

limits are designed to provide reasonable protection against harmful

interference when this equipment is operated in a commercial

environment. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area

is likely to cause harmful interference, in which case, the user is

required to correct the interference at his/her own expense.

LISTING COMPLIANCE NOTE

This product carries an ETL Listing from Intertek for one or more of

the standards listed above. Intertek is recognized by the Occupational

Safety and Health Administration (OSHA) as a Nationally Recognized

Testing Laboratory (NRTL) and accredited by the Standards Council

of Canada as a Testing Organization and Certifying Body. The ETL

Listed Mark is recognized, acknowledge and accepted by local

inspectors and Authorities Having Jurisdiction (AHJs) throughout

North America as an accepted alternative to UL and as proof of

product compliance. For more information about the NRTL program,

we encourage you to visit the OSHA Web site at www.osha.gov.

RMDC MODEL DESCRIPTIONS

APPLICABLE STANDARDS / DOCUMENTS

WARRANTY

Most products manufactured by AlarmSaf have a limited lifetime

warranty except on certain products where the warranty is specifically

designated as two (2) years. The lifetime warranty will be in effect

for the lifetime of the product. Any product that has been discontinued

by AlarmSaf or has been improperly installed, modified, or subjected

to unwarranted abuse based on the observations of the AlarmSaf

Technical Repair Department will not be considered under warranty.

AlarmSaf will not be obligated to repair or replace any product not

under warranty. A Return Material Authorization (RMA) number

issued by AlarmSaf Customer Support is required for all products

being returned. Merchandise received without an RMA number will

be refused.

1 2 3 4 5 6 7 8 ... 12 13

Comentarios a estos manuales

Sin comentarios

Alarm SAF RMBE Series Manual de instrucciones Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Cajas eléctricas Alarm SAF RMBE Series